Window Leaks After Rain: Causes, Safe Checks and Fixes in Jeddah and Makkah
Why does a window leak when the glass is fine?
When water appears under a window after wind-driven rain, most people blame the glass. In practice the glass is rarely the problem. Water usually gets in around the frame or through the bottom track, then shows up at the lowest point it can reach: the inner sill, the wall below the opening, the curtain or the floor. That is why a bead of silicone on the glass often changes nothing; the water was never passing through that spot.
A window is a frame set into an opening in a wall. Between frame and wall there is a gap filled with fixing material and a flexible sealant, and the bottom track is designed to drain whatever rain collects in it. Those two things are the first line of defence. When one ages or clogs, water that should leave the building starts to enter it.
These are the causes we see most often at the first inspection. The list is not exhaustive, but it is a sensible starting point:
- Blocked drainage slots. The bottom track of sliding windows usually has small slots or weep holes. Dust, sand and debris pile up and block them, so the track fills and overflows inward instead of draining outward.
- Aged sealant around the frame. Sealant between frame and wall is exposed to sun and heat for years. It cracks or pulls away from one surface and leaves a narrow path for capillary water.
- A sill with the wrong slope. If the outer sill is flat or slopes toward the building, water collects at the frame and looks for any gap. The slope should lead away from the window.
- No drip detail above the opening. Water running down a facade can gather at the head of the opening and run behind the frame when nothing diverts it away from the wall.
- Hairline cracks around the opening. Fine cracks at the corners of the opening can let wind-driven rain in, especially when the wall absorbs water.
- A neighbouring penetration. A split air conditioner sleeve, a pipe, a cable or a metal canopy next to the window may be the real source while the water appears to come from the window.
Why does it only leak with certain winds?
A useful clue is a window that does not leak in every storm, only when rain comes from one direction with strong wind. That means water is being pushed sideways at the opening and the facade is testing its weakest detail. A window on the sheltered side can stay dry for years while one on the exposed side leaks in the first gust. Write down which direction the wall faces; that alone can shorten an inspection considerably.
Upper floors are more exposed to wind than lower floors shielded by neighbouring buildings. Do not compare your window with a neighbour on a different floor or a different elevation. The conditions are not the same.
Window leak, condensation, roof leak or pipe leak?
Not all water near a window comes from the window. This table summarises the usual differences so you can point in the right direction before spending money:
| Situation | When water appears | Where it appears | Useful clue |
|---|---|---|---|
| Leak around frame or track | During or after wind-driven rain | Under the window, on the sill and curtain | Disappears in dry weather and repeats with the same wind direction |
| Condensation | Cold air conditioning and humid outdoor air, even without rain | Droplets on the inside face of the glass or frame | Droplets on the room side; reduces when cooling is eased |
| Roof or upper-floor leak | After rain even without wind, or when upstairs water is used | Stain on the ceiling or high on the wall above the window | Stain grows from above, not from the sill |
| Concealed pipe leak | All the time, whatever the weather | Damp wall or stain near a pipe run | Water meter keeps moving with all usage switched off |
If the signs overlap, do not rush to guess. A stain under a window next to a bathroom or kitchen may have nothing to do with the window. In that case a full leak investigation from the source, followed by a written report that explains the result and its limits, is the better route.
Record what you see before calling anyone
The best help you can give any technician is accurate information. Five minutes of notes can save an entire visit:
- Photograph the stain, the sill and the curtain with the date. If you can do so safely, photograph the window from outside from a balcony or from the ground.
- Write down when it happened: during the rain or hours later, whether there was wind, and from which side.
- Use a dry cloth to see where the water starts: a corner, the middle of the sill, under the frame.
- Look inside the bottom track: is there dirt, or standing water a day after the rain?
- Note the window type (sliding, casement, fixed) and its approximate age if you know it.
A wider version of this routine is in our guide to preparing for a leak detection visit.
A graduated water test, done safely
The idea is to recreate the conditions under control, starting low and working upward so that an upper path does not confuse the result. It is normally done by two people: one outside controlling the water, one inside watching.
- Dry the inner sill and track thoroughly, then lay white paper or cotton so the first trace of moisture shows.
- Pour water gently into the bottom track at both ends and watch whether it leaves through the drainage slots to the outside or pools.
- Move to the outer sill alone for a few minutes, then to the sides of the frame, and last to the head. Leave time between stages so effects can appear.
- Record the stage at which water showed inside. That is the decision point.
- Do not run the test near sockets or electrical panels, and move devices and cables away from the water path.
- Do not climb on an edge or an unfixed ladder to reach an upper window. Leave upper floors to people with proper fall-protection equipment.
- Do not aim a high-pressure jet at the frame and glass. It will not reproduce natural rain and can damage seals.
The limits of this test: it shows a likely water path but cannot promise to reveal every path, and it may not reproduce real wind. We treat it as one input to an assessment, not as a final verdict.
Common fixes and when they work
The fix follows the cause. There is no single treatment that suits every window. These are typical options after diagnosis:
- Cleaning and restoring the drainage slots. Right when the cause is a blockage, and it needs repeating periodically rather than being a one-off.
- Redoing the flexible joint between frame and wall. This means removing the old sealant, cleaning and drying the surfaces and applying a product suited to the substrate. A new bead over cracked sealant rarely lasts.
- Correcting the sill. A wrong slope may need work on the mortar bed or the external finish, which goes deeper than silicone.
- Treating hairline facade cracks. With a material suited to the facade, and an assessment of why the crack formed so it does not return.
- Replacing gaskets or rubber seals. When rubber has shrunk on sliding or casement windows.
In advanced cases the answer may be refitting the frame or reworking the details around it. That is a decision for a site visit, not a description over the phone.
Mistakes that waste time and money
- Putting silicone on the glass or only on the inside and concluding the problem is solved because the weather happened to be dry afterwards.
- Sealing the drainage slots in the belief that they are the entry point. That traps water in the track and makes overflow worse.
- Painting over a damp wall before the source is known, so the peeling returns within days.
- Ignoring the roof, the floor above or the pipework because the water showed up at the window.
- Testing once with a hose at high pressure and judging everything from that single result.
If mould or a persistent damp smell comes with the leak, read how to find the source of musty smells and mould on walls, because the path may extend well beyond the window.
What affects the cost?
We do not publish prices here because the right figure depends on the case. The usual drivers are the number of windows affected, the floor level and whether safe access equipment is needed, the frame type and condition, whether the fault is a surface sealant or a sill slope or facade issue, the amount of interior finish already damaged, and whether another source is involved. Ask for a quotation after an inspection that identifies the cause, rather than a generic quote in advance.
Jeddah and Makkah: does inspection differ?
The method is the same in both cities. The real differences come from the building type, the facade, the height and the orientation, not from the city name. Rain in the western region can be occasional but sometimes arrives concentrated and wind-driven, which exposes entry points that stay hidden on ordinary days. If you are in a Jeddah or Makkah neighbourhood and want an inspection, give us the district and the building type when you contact us so we can plan the visit. We do not promise any specific result before inspecting.
How Bashayir Al-Khair can help
We start with a site inspection and record the water path as you see it, and we separate a window leak from other sources such as the roof, pipework or condensation. Then we explain the options that fit and their limits. For comparison you can also read about exterior wall water seepage after rain and ceiling stains: roof leak or pipe leak. To reach us directly, the call and WhatsApp buttons above and below are ready.
Frequently asked questions
Why does my window leak only in windy rain?
Wind pushes water sideways at the opening, so it tests details that vertical rain never reaches, such as the gap around the frame or the bottom track.
Should I seal the drainage slots with silicone?
No. Those slots exist to let water out of the track. Sealing them traps water and makes overflow into the room more likely. Clean them rather than close them.
Is the leak coming through the glass itself?
Rarely. It is usually the sealant around the frame, the bottom track or the sill. Broken glass is easy to see, while water on the sill generally travels behind the frame.
How can I tell condensation from a leak?
Condensation forms as droplets on the room side of the glass or frame when air conditioning is cold and outdoor air is humid, even without rain. A leak is linked to rain and wind and shows on and below the sill.
Is new silicone around the frame enough?
Sometimes, if aged sealant was the cause and the old material is removed and the surface dried first. It will not help if the sill slope or blocked drainage is the cause.
Can I test the window myself?
Yes, gradually, away from electrics and without climbing unsafe places. Leave upper floors to trained people.
Will the leak damage the wall and paint?
It can: blistering and peeling paint, dampness and possibly mould if it continues. Drying the area after the source is fixed is an important step.
Do you inspect in Jeddah and Makkah?
Yes, we serve Jeddah and Makkah. Call or message us on WhatsApp to arrange an inspection for your location.