Getting Ready for a Leak Detection Appointment: A Practical Checklist
A surprising amount of visit time goes on hunting for the tank key, calling a neighbour, or trying to remember when the stain first appeared. The technician relies on your account of the problem and then checks it with instruments, so the better organised your information is, the faster the visit can narrow things down. This page lists what to prepare at home, describes what a typical visit involves without promising any particular result, gives you questions that are worth asking any company, and explains how apartments and villas in Jeddah and Makkah call for slightly different preparation.
Write a symptom timeline first
The single most useful thing you can hand over is a timeline. Use a sheet of paper or a phone note and record when you first noticed anything, whether it appeared suddenly or crept in, and whether it lined up with an event such as a plumbing job, a new water heater, a washing machine cycle or a rainstorm.
- The date you first saw the stain, smell or damp patch, and the date it last changed size.
- Time-of-day patterns: worse in the morning, after showers, or at night when the house is quiet.
- Any hissing, dripping or knocking sounds from walls, floors or ceilings.
- Changes in water pressure, colour or smell.
- A bill that jumped, or a meter that keeps turning while every tap is closed.
These notes help separate a pressurised-pipe problem from a drain or roof problem. If the stain is on a ceiling, our guide on telling a roof leak from a pipe leak covers the clues in more depth.
Photos and videos to send on WhatsApp
Pictures sent ahead let the technician judge what kind of problem it is and bring suitable equipment. Take sharp, well-lit shots from close up, then step back and take a wider picture that shows where the mark sits in the room.
- A close-up of the stain, peeling paint or bubbling, plus a wide shot of the whole wall or ceiling.
- A short video of the meter while everything is switched off, if you can manage it.
- The suspected source: under the sink, behind the toilet, around the mixer.
- A clear photo of the meter dial or digits with the date and time noted.
- The area directly above the damage: the bathroom upstairs, the roof or the balcony.
Put the date in the message with each photo. Comparing images over several days shows whether the damp is spreading or holding steady.
Water bills and meter readings
Have the last several monthly bills ready, or screenshots of them, and note the month when consumption began climbing. Compare summer and winter figures, because guests, travel and garden watering all shift usage. Then take a reading in the evening and another first thing in the morning, making sure nobody uses water in between. The difference is only a first indication, but it is useful. The full routine is set out in our water meter leak test guide, and reasons for an unexpected jump are in the guide to a sudden high water bill.
Know where everything is: valve, meter, tanks, roof
Find these before the appointment. If you do not know, ask the building guard, the landlord or the property manager.
- The main shut-off valve for your unit, and whether it turns easily or is stiff from years of disuse.
- The meter: inside the unit, in a street box, or in a shared meter room.
- The ground tank, the roof tank and the pump, and how to switch the pump on and off.
- The key to the roof door, the tank room and any locked cover or hatch.
- The electrical panel and the breaker that feeds the pump and the water heater.
Plans, renovation history and neighbours
Even a rough sketch of the plumbing saves hours of guessing. If no drawings exist, write down what you do know: where the wet rooms are, where pipes were routed according to the previous plumber, and whether any pipework, tiles or heaters have been changed.
- Dates and descriptions of past renovations: retiling, repiping, waterproofing work.
- What the pipes are made of, if the owner or a plumber can tell you.
- Whether the apartment above, below or alongside has noticed damp or higher bills.
- Whether the building shares a meter, a tank or drainage stacks.
Asking the neighbours matters most in apartments because the source can sit in someone else's unit. Our guide to a leak from the apartment above walks through the sensible steps.
What to stop using, and what to leave alone
If you suspect a particular fixture or appliance, stop using it until the technician has seen it, and note what you did. That preserves evidence and limits further damage. What you should avoid is shutting the whole supply off without a plan, because the technician sometimes needs the system under pressure to test it.
- Pause the washing machine or dishwasher if either is under suspicion, and put a note up for the household.
- If water is visibly gushing, close the nearest valve or the main one, then tell the technician what you closed and when.
- Place a container or towel under a drip and record how much it collects over a known period.
Clear the way: access, pets and valuables
Make sure the technician can reach every area that matters: bathrooms, kitchen, tank room, roof, garden and meter room. Empty the cupboard under the sink, move light furniture away from the affected wall, and cover or relocate anything precious.
- Keep pets in a quiet room; some are frightened by equipment and others slip onto the roof.
- Tell everyone at home about the appointment and agree who will accompany the technician.
- Leave a clear spot for equipment and decent lighting in the tank room.
- Have someone who knows the property on hand to answer questions.
What the visit usually involves
Interview and visual inspection
The technician starts with questions much like those in your timeline, then walks the property looking at stains, flaking paint and sealant around basins. A moisture meter gives relative readings: it compares one spot with another but does not identify where the water came from on its own.
Line tests and instruments
Next may come a meter test with all outlets closed, and a pressure test on a specific line to see whether it holds. A pressure test shows that water is being lost but not where; see whether a pressure test can find the leak. Where the site suits it, thermal imaging or an acoustic listening device may be added, and each has limits explained in thermal camera versus acoustic detection. The wider toolkit is described in our non-destructive methods guide.
What an inspection can and cannot tell you
A visit collects evidence and narrows possibilities. Sometimes it pinpoints the spot; sometimes it only identifies a zone. No honest technician promises an outcome before seeing the property.
| Tool or step | What it can show | Where it falls short |
|---|---|---|
| Moisture meter | Areas wetter than their surroundings | Cannot name the source or separate a leak from condensation |
| Meter test | Whether water is being used with everything off | Does not locate the loss; a tank or heater can also affect it |
| Pressure test | Whether an isolated line loses pressure | Does not say where |
| Thermal camera | Surface temperature differences | Cannot see water inside a wall; sun and air-conditioning interfere |
| Acoustic listening | The sound of escaping water | Weaker with background noise, plastic pipe and depth |
Questions to put to any leak detection company
- Which methods will you use on my property, and why those?
- What are their limits, especially with plastic or deeply buried pipe?
- What will the report include: photos, readings, the probable location, recommendations?
- Will anything need to be broken or opened, who decides, and when do I give consent?
- What happens if no leak is found, and will I still receive a report of what was ruled out?
- Is making good the opened area included, or are repair and finishing separate jobs?
- Roughly how long will the visit take, and who needs to be present?
Straight answers about limits are a good sign; a promise of a certain result before inspection is a reason for caution. For how scope affects price, see the cost and pricing guide.
Mistakes people make before the appointment
- Breaking tiles or chasing walls to find the pipe before any diagnosis, which destroys evidence and raises repair cost.
- Painting or filling the stain to hide it, which removes a clue and often lets it return.
- Shutting the water off suddenly without telling neighbours or the household, or stopping the pump or heater without draining.
- Swapping a fitting or mixer as an experiment and forgetting to record it.
- Taking one neighbour's opinion as a diagnosis.
- Waiting because the mark looks small while damp spreads out of sight.
Apartment or villa: how preparation differs
In an apartment you share a meter, tank or drainage stacks with others, so you may need the guard's or building manager's permission to reach the meter room and roof, and you must work out whether the source is yours or next door. A villa gives you more to look after: a ground tank and a roof tank, garden lines, a roof and possibly buried pipe, so collect what you know about outdoor routes and where the main meter sits. More on the contrast is in apartment versus villa leak detection.
What shapes the cost, without numbers
Several factors move the price of a visit, and none needs a figure to explain: the size of the property and the number of bathrooms or floors, whether the suspect line is indoors or buried, how hard it is to reach the roof or tank, how long the inspection takes and how many instruments it needs, and whether a second visit follows once something has been opened. Good preparation trims wasted time but cannot change the nature of the fault. We do not quote amounts here because they depend on the case.
Jeddah and Makkah: local points to keep in mind
In Jeddah, humid coastal air and salt can blur the line between ambient dampness and a real leak. In Makkah, hot dry weather makes roofs expand and crack over time. Rare but heavy rain can overload drainage and roofs and produce stains unrelated to pipes, and both cities contain a mix of old and new buildings, so knowing the age of yours helps. See our services for leak detection in Jeddah and leak detection in Makkah, or browse the full leak detection section.
Frequently asked questions
What should I do first if I think I have a leak?
Note when the sign first appeared and photograph it, then switch off all water use and watch the meter. If it moves, hidden consumption is likely and worth inspecting. Do not break tiles or paint over the mark before a technician has seen it, and send the photos by WhatsApp.
Should I send photos before the visit?
Yes. Photos help the technician gauge the problem and bring the right equipment. Send one close-up and one wide shot of the area, plus the meter. Do not expect a final diagnosis from pictures alone, since the on-site inspection is what counts.
Do I need to shut the water off before the technician comes?
Not always. If water is gushing, close the nearest valve or the main valve and tell the technician. If the leak is slow, leave things as they are, because the line may need to be under pressure for testing. Ask when you book.
How long does a leak detection visit take?
It varies with the size of the property, how complicated the symptoms are and how easy the roof and tank are to reach. A small flat may be quick while a villa takes longer. Ask for an estimate when booking; preparing in advance reduces wasted time.
Will the technician break my walls or tiles?
Inspection starts with non-destructive methods. If confirming the spot needs a small opening, the decision should be put to you and you should agree beforehand. Ask who restores the finish and whether that is part of the job or separate.
What if no leak is found?
A single visit may not find the cause, especially for intermittent or deep leaks. Ask for a report listing what was checked, what was ruled out and what is worth monitoring, and discuss repeat readings after a few days or a follow-up check.
Do my neighbours or building management need to be involved?
In apartments usually yes, because the source may be next door or in a shared stack, and roof or meter-room access needs permission. Tell them the visit date. Who bears responsibility depends on your contract and the building rules, so document everything and consult the management or a qualified adviser.
Should I keep using the suspected bathroom or appliance?
Use it as little as possible until the technician has seen it, while keeping the home liveable. If there is dampness near electrics, stop using that area and call a qualified electrician.
Contact us
If you are planning a visit in Jeddah or Makkah, call us or send photos of the damp area and the meter on WhatsApp along with your timeline, and we will arrange the appointment and tell you what to have ready.